Search | R107 | Transmission

In this 5 and a half minute video Kent will show you how to replace the o-ring seal at the base of the dip stick / fill tube going into the automatic transmission case on the right side.

Kent will share his knowledge from years of doing pressure tests on these old transmissions. Don't be afraid to do this. It is definitely a entry level DIY procedure. 

PLEASE NOTE: As stated earlier, Kent does not cover the overhaul of the valve body in this video series. That could be another long series all by itself. He will show you how to make the K1 accumulator upgrade.

Now, for the part you have been waiting for —and perhaps the most critical. If you forget to install even a single small needle bearing or a couple of thin washers, you could encounter some serious problems.

In this 19-minute session, Kent will remove a rear oil pump from an early 722.3, disassemble it, and demonstrate some of the challenges associated with resealing it.  72234CLASS

This is a comprehensive video (30 minutes long) that provides an in-depth explanation of testing and adjusting the modulation pressure in the 722.3 and 722.4 transmissions.

Out of years of frustration trying to adjust the modulator during a test drive, Kent came up with a better and faster way to make adjustments by just "reaching" under the car. This little device replaces the plastic cap during testing and adjustment.

In this 13-minute session, Kent will open up the planetary gear assembly with the one-way clutch and show you how to put in the new seals. This one is a little bit tricky. You have to be careful not to knock the clutch assembly apart. It also takes some effort to get it all back together.

In this xx-minute video, Kent will explain how to set up and use the different components in his kit (see below) to test modulation pressure in a 1981 to 1995 automatic transmission. This should be done when replacing the modulator or after rebuilding a transmission.

In Part 7 of this transmission rebuild training class, Kent will prep the drums for reassembly with the new seals. Installation of the piston in the K1 drum can be particularly challenging.

In Part 2 of this training series, Kent will show you what you will want to inspect before you begin ordering parts for a transmission overhaul. In most cases, you will only need gaskets, seals, and clutches, but you want to make sure. 72234CLASS

In this detailed 22-minute video instruction, Kent will show you how to use his kit to perform a power drain on most 1965 to 1995 automatic transmission.

In this 15-minute video, Kent will show you step-by-step how to safely remove the Bowden cable without damaging it and how to install it to get the proper connection. This is not as easy as it looks, and you can break it if you are not careful.